Digi 90000566_H Reminder=onoff, Reminderinterval=seconds, Triggerinterval=seconds, Mode=match

set alarm

reminder={onoff}

The type of reminder sent.

on

An email or SNMP trap is sent periodically while the alarm-triggering event is active. The interval is based on the value of the “reminder_interval” option.

off

An email or SNMP trap is sent only when an alarm is triggered.

reminder_interval=seconds

The minimum reminder interval in seconds. Indicates how often an email or SNMP trap is sent when the “reminder” option is set to “on” and an alarm-triggering event is active.

trigger_interval=seconds

The minimum trigger interval in seconds. If the “reminder” option is set to “off,” this option indicates the minimum amount of time that is allowed between alarm-triggered emails or SNMP traps.

Data pattern matching-based alarm options

In data pattern match mode, an alarm will be triggered when a pattern is found in the stream of serial data. These options are used for setting alarms in data pattern match mode:

mode=match

Sets the alarm to match mode.

match=string

A string that triggers an alarm if the data pattern is found in the incoming serial stream. The maximum length of this string is 40 characters, including escape sequences for special characters. For more details on the escape sequences, see "Entering Special Characters in String Values" on page 13. The maximum parsed length of this string is 10 characters. That is, this string must reduce down to a 10-character string when the escape sequences are processed.

Signal-strength-based alarm options

Options for setting alarms based on signal strength are supported in Digi Cellular Family products only. Note that not all signal-strength options are available with all radios. To determine which signals can be monitored, use the “display mobile” command. If a signal is displayed, it can be monitored.

mode=rssi_gsm

Sets the alarm to signal-strength mode for a GSM radio.

mode=rssi_1xrtt

Sets the alarm to 1xRTT RSSI signal-strength mode for a CDMA radio.

mode=rssi_1xevdo

Sets the alarm to 1xEV-DO RSSI signal-strength mode for a CDMA radio.

mode=ecio_1xrtt

Sets the alarm to 1xRTT Ec/Io signal-strength mode for a CDMA radio.

76 Chapter 2 Command Descriptions