Digi 90000566_H manual Connect WAN and ConnectPort Display, Set permissions s-udpserial=read

set udpserial set udpserial

Devices	This command is supported in all Digi Connect products except Digi
supported	Connect WAN and ConnectPort Display.
Purpose	Use this command to set up the UDP serial feature, or display current UDP
	serial settings.
	The UDP serial feature allows data to be sent between the serial port and
	one or more remote network destinations using the UDP protocol. When
	this feature is enabled for a given serial port, data sent to the serial port will
	be sent out to the configured destinations. Also any time data is sent to the
	UDP serial service (IP port 2101) and the serial port is not being used by
	another service, the data will be sent to the serial port.
Required	For Digi Connect products with two or more users, to use this command,
permissions	permissions must be set to one of the following:
	• For a user to display the UDP serial settings for the line on which they
	are logged in: “set permissions s-udpserial=r-self”
	• For a user to display the UDP serial settings for any line:
	“set permissions s-udpserial=read”
	• For a user to display and set the UDP serial settings for the line on
	which they are logged in: “set permissions s-udpserial=rw-self”
	• For a user to display the UDP serial settings for any line, and set UDP
	serial settings for the line on which the user is logged in:
	“set permissions s-udpserial=w-self-r”
	• For a user to display and set the UDP serial settings on any line:
	“set permissions s-udpserial=rw”
	See "set permissions" on page 157 for details on setting user permissions
	for commands.
Syntax	Set general UDP serial forwarding characteristics for a serial port
	set udpserial port=range [state={onoff}]
	[sendcount=bytes] [sendtime={0time}]
	[endpattern=string] [strippattern={onoff}]
	[sid={onoff}] [sidstring=string}
	[closetime=time]
	Set UDP destinations for a given serial port
	set udpserial port=range range=1-64 [description=string]
	[active={onoff} [ipaddress=ip address}
	[ipport=ip port]
	Display current UDP serial settings
	set udpserial [port=range [range=range]]

216 Chapter 2 Command Descriptions