Digi 90000566_H manual Show, Issued to the device, User permissions for commands, Option

				show
show
Devices	This command is supported in all Digi Connect products.
supported
Purpose	Displays the current settings in a device, including current configuration
	settings, boot code loaded in the device, and the effects of commands
	issued to the device.
Required	For Digi Connect products with two or more users, for this command to
permissions	display current device settings, the various “set” commands must have be
	set to either “read” or “r-self,” depending on the available permissions for
	the commands. See "set permissions" on page 157 for details on setting
	user permissions for commands.
Syntax	show option [port=range] [range=range]
Options	option
	Specifies which settings in the device to show. The following options can
	be specified. The use of the “port” and “range” options on the show
	command depends on whether the command that was used to configure
	the settings uses the “port” and “range” options as well. If you are viewing
	the PDF file of this document, click the “set” commands in the “Displays
	settings...” column to go to the command descriptions.
		Displays settings	Works w/	Works w/
	Option			range
		configured by	port option
				option
	accesscontrol	set accesscontrol	No	No
	alarm	set alarm	No	Yes
	arp	The arp table. This	No	No
		option is not
		associated with a “set”
		command.
	autoconnect	set autoconnect	Yes	No
	bsc	set bsc	No	No
	buffer	set buffer	Yes	No
	ddns	set ddns	No	No
	dhcpserver	set dhcpserver	No	Yes
	ekahau	set ekahau	Yes	No
	ethernet	set ethernet	No	No
	forwarding	set forwarding	No	No
	gpio	set gpio	No	Yes

Chapter 2 Command Descriptions 249