Digi 90000566_H manual Access the Command Line, Configure an IP Address

	Access the Command Line
Feature/Task	Commands
Wireless devices	"set wlan" on page 241.
	"set ekahau" on page 104.

Access the Command Line

To configure devices using commands, you must first access the command line, and then log on as needed.

This procedure assumes that you have already configured the Digi device with an IP address.

1.To access the Command-Line Interface for the Digi device, enter the following command from a command prompt on another networked device, such as a server:

#> telnet ip address

where ip address is the Digi device’s IP address. For example:

#> telnet 192.3.23.5

2.If user authentication has been set up for the device, (that is, a user- name and password have been set up for the device), a login prompt is displayed. If you do not know the user name and password for the device, contact the system administrator who configured the device. The default username is “root” and the default password is “dbps.”

Configure an IP Address

If the device to which you will be issuing commands has not already been assigned an IP address, or if the IP address needs to be modified from its initial configuration, see the Digi product’s User’s Guide for details on configuring an IP address.

Chapter 1 Introduction 11