Digi 90000566_H manual Info, Ethernet, Icmp

info

info

Devices	This command is supported in all Digi Connect products.
supported
Purpose	Displays statistical information about a device.
	The “info” command displays statistical information about a device over
	time. In contrast, the “display” command’s focus is on real-time information,
	while the “status” command displays the status of outgoing connections
	(connections made by “connect,” “rlogin,” or “telnet” commands).
	Command options allow display of the following categories of statistics:
	•	Device statistics
	•	Ethernet statistics
	•	ICMP statistics
	•	IP statistics
	•	Mesh network statistics
	•	Serial statistics
	•	TCP statistics
	•	UDP statistics
	• WLAN statistics (for wireless devices only)
	The statistics in these tables are those gathered since the tables were last
	cleared. The statistics tables are cleared by rebooting the Digi device.
	Status and statistics for mobile communications
	To display information and statistics for mobile/cellular communications,
	issue a “display mobile” command. To display SureLink statistics, issue a
	“display pppstats” command. See "display" on page 27.
Syntax	info {deviceetherneticmpipmeshserialtcpudpwlan}
Options	For a description of the statistics displayed by all these options, see
	“Results” on the following page.

device

Displays statistics from the device table. This information includes device-model information, MAC address, current Boot and POST code, firmware, memory usage, utilization, and uptime. The information displayed by this option is the same as that displayed by the “display device” command (see "display" on page 27).

ethernet

Displays statistics from the Ethernet table.

icmp

Displays statistics from the ICMP table.

ip

Displays statistics from the IP table.

Chapter 2 Command Descriptions 41