Digi 90000566_H manual Service table, Device is configured for IP passthrough, Set surelink on

set service

Examples	Disable service
	#> set service range=1 state=off
	Change the network port (ipport) of a service
	#> set service range=1 ipport=500
	Displaying the service table
	In this example, the “set service” command displays the entire service
	table.
	#> set service
	Displaying an entry in the service table
	In this example, the “set service” command displays a range of entries in
	the service table.
	#> set service range=2-4
	Allow outgoing data that is unacknowledged or less than maximum
	segment size
	#> set service ra=5 nodelay=on
See also	• "revert" on page 61.
	• "set network" on page 149.
	• "set passthrough" on page 153 for information on network services and
	applications that are enabled and disabled by default when a Digi
	device is configured for IP passthrough.
	• "show" on page 249.
	• For descriptions of the Connectware Manager application and related
	settings, see "set mgmtconnection" on page 137, "set mgmtglobal" on
	page 140, and "set mgmtnetwork" on page 143.
	• For more information on SureLink Link Integrity Monitoring tests, see
	"set surelink" on page 202.

Chapter 2 Command Descriptions 197