Digi 90000566_H manual Port= range, Sendcount= bytes, Sendtime=0 time

	set udpserial
Options	Options for setting general UDP serial forwarding characteristics
	port=range
	Used to specify the serial port. Optional on a single-port device.
	state={onoff}
	Used to enable or disable sending data from the serial port to remote
	network destinations. The default is “off.”
	sendcount=bytes
	The number of bytes received from the serial port that will cause the data
	to be sent on to the network destinations. This trigger cannot be disabled.
	The default is 1024 bytes.
	sendtime={0time}
	The amount of idle time, in milliseconds, allowed before sending data to
	the network. If no data is received on the serial port for the time specified
	by this option, any buffered data will be sent on to the network
	destinations. A value of 0 (zero) disables this trigger.

endpattern=string

If this string is set, any pattern match of data received from the serial port will cause the data to be sent on to the network destinations. The maximum length of this string is 16 characters, including escape sequences for special characters. For more details on the escape sequences, see "Entering Special Characters in String Values" on page

13.The maximum parsed length of this string is 4 characters. That is, this string must reduce down to a 4-character string when the escape sequences are processed.

strippattern={onoff}

Determines how the data specified by the “endpattern” option is handled.

on

The endpattern that is found is stripped from the stream before any data is to be sent on to the network destinations.

off

The endpattern is not stripped from the stream before data is sent on to network destinations.

The default is “off.”

Chapter 2 Command Descriptions 217