Digi 90000566_H manual Send

	send
send
Devices	This command is supported in Digi Connect Family and Digi Cellular
supported	Family products only. Not supported in ConnectPort Display.
Purpose	Sends a Telnet control command, or special-character sequences, when
	connected using the Telnet client.
Required	For Digi Connect products with two or more users, permissions must be set
permissions	to “set permissions telnet=execute” to display or set Telnet operating
	options. See "set permissions" on page 157 for details on setting user
	permissions for commands.
Syntax	send {aoaytbrkecelescapegaipnopsynch}
Options	ao
	Sends the “abort output” signal to discard output buffered on the peer.
	ayt
	Sends the “are you there” signal to test whether a host is still active.
	brk
	Sends the “break” signal to interrupt the executing application.
	ec
	Sends the “erase character” to delete the previous character.
	el
	Sends the “erase line” signal to delete the entire current line.
	escape
	Sends the “escape” character.”
	ga
	Sends the “go ahead” signal.
	ip
	Sends the “interrupt process” signal to terminate the program running on
	the peer.
	nop
	Sends the “no operation” signal to the peer.
	synch
	Sends the “synchronize process” signal to the peer.
Examples	Send an “interrupt process” signal
	#> send ip
	Send an “are you there” signal
	#> send ayt
See also	See "telnet" on page 255 for information on establishing Telnet sessions.

Chapter 2 Command Descriptions 67