Digi 90000566_H manual Network IP destination when data arrives on the serial port, Set network on

set autoconnect

Examples	Set autoconnect on with trigger
	This example shows setting autoconnect to connect to the TCP port (2101)
	of the network IP destination when data arrives on the serial port.
	#> set autoconnect state=on trigger=data ipaddress=10.0.0.1 ipport=2101
	Allow outgoing data that is either unacknowledged or less than maximum
	segment size
	#> set autoconnect port=1 nodelay=on
See also	• "revert" on page 61.
	• "set network" on page 149.
	• "set serial" on page 189.
	• "set tcpserial" on page 212.
	• "show" on page 249.

84 Chapter 2 Command Descriptions