Digi 90000566_H manual Interval=10-65535, Ipport=1-65535, Dnsfqdn1=dns fqdn, Dnsfqdn2=dns fqdn

set surelink

max_consecutive_failures={1-255, 0=off} (probe failures before link reset)]

The maximum number of consecutive Link Integrity Monitoring tests. After this number is reached, the mobile connection should be disconnected and reestablished.

This value must be between 1 and 255. The default is 3. A value of 0 turns off this feature. When the mobile connection is reestablished, the “consecutive failures” counter is reset to zero.

Note: if the mobile connection is disconnected for any reason (including not as a result of a link integrity test failure), the consecutive failures count is reset to zero when the mobile connection is reestablished.

interval=10-65535

Specifies the interval, in seconds, at which the selected Link Integrity Monitoring test is initiated or repeated. A new test will be started every specified number of seconds while the mobile connection is established. This value must be between 10 and 65535. The default is 240.

If the configured interval is less time than it takes a test to complete, the next test will not be initiated until the previous (current) test has completed.

ICMP ping link test options

pingaddr1={ipv4 addressfqdn} The first host to test.

pingaddr2={ipv4 addressfqdn}

The second host to test, if the first host fails.

TCP connection link test parameters:

ipaddr1={ipv4 addressfqdn} The first host to test.

ipaddr2={ipv4 addressfqdn}

The second host to test, if the first host fails.

ipport=1-65535

The TCP port number to connect to on the remote host. The default is 80.

DNS lookup link test parameters

dnsfqdn1=dns fqdn

The first hostname to look up.

dnsfqdn2=dns fqdn

The second hostname to look up, if the first hostname fails.

Example set surelink system_reset_connect_failures=30

206 Chapter 2 Command Descriptions