Digi 90000566_H manual Authmethod=nonePAPCHAPboth, Pap, Chap, Both, Passive=onoff

	set pppoutbound
Options	port=range
	The physical interface to which the PPP outbound configuration applies.
	Required.
	state={enableddisabled}
	The state of the interface. The default is “disabled.”
	auth_method={nonePAPCHAPboth}
	Determines whether authentication is required for outbound PPP
	connections and, if so, what kind.
	none
	The remote user does not require PPP authentication.
	pap
	Password Authentication Protocol (PAP) authentication is required.
	chap
	Challenge Handshake Authentication Protocol (CHAP) authentication
	is required.
	both
	Both CHAP and PAP authentication are required.
	The default is “none.” CHAP authentication works between two Digi
	Connect products. CHAP will be negotiated to PAP for all other connec-
	tions.
	passive={onoff}
	Specifies whether the device server waits for the remote system to begin
	PPP negotiations, or can initiate PPP negotiations on its own.
	on
	The device server waits for the remote system to begin PPP
	negotiations.
	off
	The device server may initiate PPP negotiations.
	The default is “off.”
	Do not set both sides of a PPP connection to “passive=on.”
	remote_address={negotiatedip address}
	The address of the peer at the other end of the outbound PPP
	connection. Either a specific address or the keyword “negotiated” can be
	specified; “negotiated” means that the address will be accepted from the
	peer. An IP address of all zeroes is equivalent to specifying the keyword
	“negotiated.”
	local_address={negotiatedip address}
	The IP address of the local end of the PPP outbound connection. Either
	a specific address or the keyword “negotiated” can be specified;
	“negotiated” means that the address will be accepted from the peer. An
	IP address of all zeroes is equivalent to specifying the keyword
	“negotiated.”

Chapter 2 Command Descriptions 167