Digi 90000566_H manual To=serveripaddressfilename, From=serveripaddressfilename

backup backup

Devices	This command is supported in all Digi Connect products.
supported
Purpose	Save the device configuration to a TFTP server located on the network, or
	restores the configuration from a saved copy on the TFTP server.
Required	For Digi Connect products with two or more users, permissions must be set
permissions	to “set permissions backup=execute” to use this command. See
	"set permissions" on page 157 for details on setting user permissions for
	commands.
Syntax	backup [to=serveripaddress[:filename]
	from=serveripaddress[:filename]print]
Options	to=serveripaddress[:filename]
	The IP address of the TFTP server to which the configuration will be
	saved, and the filename that the configuration will be saved as. If a
	filename is not specified, the default filename of config.rci is used.
	from=serveripaddress[:filename]
	The IP address of the TFTP server and the filename from which the
	configuration will be restored. If a filename is not specified, the default
	filename of config.rci is assumed.
	print
	Prints out the current device configuration.
Example	#> backup from=10.0.0.1:config.rci
See also	"set rciserial" on page 184. The “set rciserial” command allows a
	configuration file to be loaded over a serial port when the DSR input signal
	is high.

18 Chapter 2 Command Descriptions