Digi 90000566_H manual Set autoconnect

set autoconnect

set autoconnect

Devices	This command is supported in Digi Connect Family and Digi Cellular
supported	Family products only. Not supported in ConnectPort Display.
Purpose	Used to establish an automatic connection (autoconnection) between the
	serial port and a remote network destination, and to display current
	autoconnect settings.
Required	For Digi Connect products with two or more users, to use this command,
permissions	permissions must be set to one of the following:
	• For a user to display autoconnect settings for the line on which they are
	logged in: “set permissions s-autoconnect=r-self”
	• For a user to display autoconnect settings for any line:
	“set permissions s-autoconnect=read”
	• For a user to display and set the autoconnect settings for the line on
	which they are logged in: “set permissions s-autoconnect=rw-self”
	• For a user to display autoconnect settings for any line, and set the
	autoconnect settings for the line on which the user is logged in:
	“set permissions s-autoconnect=w-self-r”
	• For a user to display and set the autoconnect settings on any line:
	“set permissions s-autoconnect=rw”
	See "set permissions" on page 157 for details on setting user permissions
	for commands.
Syntax	Configure autoconnect
	set autoconnect [port=range]
	[state={onoff}]
	[trigger={alwaysdatadcddsr}]
	[service={rawrloginssltelnet}]
	[description={string}]
	[ipaddress=ipaddress]
	[ipport=ipport]
	[connect_on_string=string]
	[flush_string={onoff}]
	[keepalive={onoff}]
	[nodelay=onoff]
	Display autoconnect settings
	set autoconnect [port=range]

Chapter 2 Command Descriptions 81