Digi 90000566_H Options ipforwarding=onoff, Staticrouteindex=1-8, Action=addchangedelete, Add

set forwarding

Change an existing static route table entry

To change an existing static route table entry, these options are required:

staticrouteindex={1-8}

action=change

[one or more additional options]

Delete a static route table entry

To delete a static route entry, these options are required:

staticrouteindex={1-8}

action=delete

Enable a static route table entry

To enable a static route entry, all of its options must be specified (on this or a previous command) and valid. That is, an entry can be enabled only if it is completely valid.

When a new entry is added or a change is made to a static route entry and that entry is enabled, the change is applied immediately to the IP routing table. If a static route entry is disabled or deleted, it is removed immediately from the IP routing table.

Display IP forwarding settings show route

Display the current active IP routing table display route

Options ipforwarding={onoff}

Enables or disables IP forwarding.

on

Enables IP forwarding.

off

Disables IP forwarding.

staticrouteindex={1-8}

Specifies which of the 8 static route table entries is to be acted upon.

action={addchangedelete}

Specifies the action to be performed on the selected static route table entry.

add

Add a new entry.

change

Change one or more options of an existing entry.

delete

Delete an entry, resetting all its options to defaults (empty).

110 Chapter 2 Command Descriptions