Digi 90000566_H manual Item=scope, Action=setrevert, Set, Revert

set dhcpserver

Configure the DHCP server scope (“item=scope”) set dhcpserver item=scope

[action={setrevert}]

[enabled={onoff}] [startip=ip address] [endip=ip address]

[leasetime={timeinfinite}] (in seconds, 0=default (86400)} [offerdelay=0-5000] (time in milliseconds, default 500} [conflictdetect={onoff}]

Configure the scope's address reservations (“item=reservation”)

In this type of configuration, the DHCP server assigns a particular IP address to a Digi device, rather than a random address from a pool.

set dhcpserver item=reservation [action={setrevert}] [range={1-16all}] [enabled={onoff}]

[ip=ip address]

[clientid=client MAC address] {e.g., 00:40:9D:12:34:56} [leasetime={timeinfinite}] {in seconds, 0=default (use scope's time)}

Configure the scope's address exclusions (“item=exclusion”) set dhcpserver item=exclusion

[action={setrevert}] [range={1-4all}] [enabled={onoff}] [startip=ip address] [endip=ip address]

	Display current DHCP server settings
	set dhcpserver
Options	Options for configuring the DHCP server scope (“item=scope”)
	item=scope

Specifies that the DHCP server configuration settings apply to the scope of IP addresses for a network. A scope is the full consecutive range of possible IP addresses for a network. A scope typically defines a single physical subnet on your network, to which DHCP services are offered. A scope is the primary way for the DHCP server to manage distribution and assignment of IP addresses and related configuration parameters to its clients on the network.

action={setrevert}

Specifies the action to be performed by the “set dhcpserver” command.

set

Sets the DHCP configuration settings to the specified values. This is the default setting that is used if this option is not specified.

revert

Resets the configuration settings for the specified item to default values.

Chapter 2 Command Descriptions 97