Digi 90000566_H manual Rxtimeout=milliseconds

set bsc

poll_interval=milliseconds

Specifies the time interval between successive attempts to poll the bisync terminal. The default value is “1000,” or 1 second.

rx_timeout=milliseconds

Specifies the maximum time interval between sending data and receiving a response from the bisync terminal. If the expected response is not received within this interval, the data being sent is normally repeated to accommodate serial line transmission errors. The default value is “3000,” or 3 seconds.

tx_retries=0-255

Specifies the maximum number of additional attempts to send data when a response is not received from the bisync terminal. If the expected response is not received after all attempts, the data being sent is lost. The default value is “3”.

Options for configuring bisync network services

mode={clientserver}

Specifies whether the Digi device server is in bisync server or client mode. This is the mode that will be used to establish a connection with the host.

client

In bisync client mode, the Digi device server will initiate a connection to the server hostname, which is either specified as a name or an IP address on the “server_hostname” option and using the TCP port specified by the “server_port” option.

server

In bisync server mode, the Digi device server will listen for a connection from the network, using the TCP port specified by the “server_port” option. Note that configuring server mode involves specifying the “server_port” option but not the “server_hostname” option.

server_hostname={nameip address} (used in bisync client mode) The server hostname to which the Digi device server connects in bisync client mode. This option can be specified as a name or an IP address.

server_port=tcp port (used in both bisync client and server mode) For bisync client mode, this value is the TCP port that Digi device server uses to make a connection to the server.

For bisync server mode, this value is the TCP port on which the Digi device server listens for a connection from the network.

use_ssl={onoff}

Enables or disables encrypting the network connection using the Secure Sockets Layer (SSL) protocol. When enabled, the bisync data sent over the TCP/IP network is encrypted using SSL.

tpdu_header={onoff}

Enables or disables a Transport Protocol Data Unit (TPDU) header that is added to IP packets transmitted between the host and the Digi device server.

88 Chapter 2 Command Descriptions