Digi 90000566_H manual Port=serial port

set ia

type={discardipmaptonopathserial} Defines the type of destination for this route.

discard

Messages destined for this route entry are discarded without error.

ip

Messages destined for this route entry are forwarded to the entered IP address. If you enter the IP address as 0.0.0.0, the Digi device’s IP address is used to fill in the IP address, and the “replaceip” function is applied. For example, if the IP is 0.0.0.0, the Digi device’s IP address is 143.191.23.199, and the protocol address of the message is 45, then the remote IP address used will be 143.191.23.45.

mapto

Messages destined for this route entry are reevaluated as-if having the protocol address configured within this entry.

nopath

Messages destined for this route entry are returned to sender with a protocol-defined error message.

serial

Messages destined for this route entry are forwarded to a serial port.

protocol={modbusrtumodbusasciimodbustcp} The protocol used for the connection.

modbusrtu

Modbus/RTU – 8-bit binary per www.modbus-ida.org specification.

modbusascii

Modbus/ASCII – 7-bit ASCII per www.modbus-ida.org specification.

modbustcp

Modbus/TCP – or “Open Modbus” per www.modbus-ida.org specification.

Can be enabled with UDP/IP as well as TCP/IP.

port=serial port

Defines the serial port for the route table entry. This option applies only if the route “type=serial.”

transport={tcpudp}

Defines whether the outgoing connection is TCP (connected) or UDP (unconnected). The default is “tcp.” This option applies only if the route “type=ip.”

ipaddress=ip address

The destination IP address of the entry. This option applies only if the route “type=ip.”

128 Chapter 2 Command Descriptions