Digi 90000566_H manual Set bsc

	set bsc
set bsc
Devices	This command supported in Digi Connect WAN Sync only.
supported
Purpose	Configures the binary synchronous feature (also known as bisync or BSC)
	that provides bisync to IP protocol configuration. This feature allows you to
	attach a bisync terminal to the Digi device server’s serial port. The Digi
	device server emulates the host by polling the terminal. The bisync data is
	forwarded to the host over the TCP/IP network.
	The Digi device can be configured in either client or server mode for bisync
	communications.
	Configuring the bisync feature involves:
	• Enabling/disabling bisync communications and configuring serial
	settings.
	• Configuring polling settings.
	• Configuring the network service settings for bisync communications.
	Setting any of the bisync options will apply those options immediately, with
	the current network connection. If the Digi device server is up and running,
	has a network connection to the host, and you change the polling address,
	the Digi unit will apply that to the next poll command it sends. However, if
	you change anything on the network options, the current network
	connection will be terminated, and a new connection will be established
	using the new configuration.
Required	For Digi Connect products with two or more users, to use this command,
permissions	permissions must be set to one of the following:
	• For a user to display bisync settings: “set permissions s-bsc=read”
	• For a user to display and set bisync settings: “set permissions
	s-bsc=rw”
	See "set permissions" on page 157 for details on setting user permissions
	for commands.

Chapter 2 Command Descriptions 85