Digi 90000566_H manual Poproto1-64=tcpudp, Pocount=1-64=number of ports in range, minimum

set nat

poproto[1-64]={tcpudp}

The IP protocol associated with this port forwarding entry.

tcp

A TCP port is forwarded.

udp

A UDP port is forwarded.

pocount=[1-64]=number of ports in range, minimum 1

The number of consecutive ports in a port-forwarding range. This option allows you to forward more than one port in a single port-forwarding entry. When a range is configured, the first port in the range is specified, and the full range is indicated in the displayed entry information. The default is 1.

poexternal[1-64]=number of ports in range, minimum 1

The external (or public) port that will be forwarded for this entry.

pointernal[1-64]=number of ports in range, minimum 1

	The internal (or private) port to which packets will be forwarded for this
	entry. This value is a port number on the host whose IP address is
	specified by the “poip” option value for this entry.
	poip[1-64]=ipaddress
	The IP address of the host to which packets will be forwarded for this
	entry.
Examples	Enable NAT and specify settings for port forwarding entry 1
	This example command will enable the forwarding of TCP packets
	received at port 4009 of the public (PPP) interface of the device server, to
	TCP port 7008 of the host whose IP address is 143.191.1.228 on the
	Ethernet side of the device server.
	#> set nat enabled=on poenabled1=on poproto1=tcp poexternal=4009
	pointernal=7008 poip=143.191.1.228
	Display NAT and port/protocol forwarding settings
	#> set nat
See also	• "set forwarding" on page 109.
	• "revert" on page 61.
	• "show" on page 249.

148 Chapter 2 Command Descriptions