Digi 90000566_H Last reset reason, Idle, Lcp keepalive, Surelink, No service, No carrier, Unknown

display

last reset reason

The reason for the most recent reset of the PPP link.

idle

An idle reset brought down the link last.

lcp keepalive

An LCP keepalive reset brought down the link last.

surelink

Surelink tests failed and brought down the link.

no service

The modem received a “no service” indication on the monitoring channel, and brought down the link.

no carrier

The modem dropped the link (hard), and was responsible for the termination of the last link.

administrative

Someone issued a “kill” command, or disconnected the PPP link in the Web user interface’s Connections page.

non-administrative

The network initiated closure of the last link.

unknown

The link was brought down for unknown reasons. This status is also displayed if the PPP connection has not been brought down since the Digi device was last rebooted. Since it is not possible for "last reset reason" information to persist across resets, this unknown state indicates that it is not clear which event may have been responsible for a reset that occurred in a prior life of the device.

tx timer

The time, in seconds, after which if no data is transmitted, the PPP link is disconnected. Typically, this value is 0 (disabled).

rx timer

The time, in seconds, after which if no data is received, the PPP link is disconnected. An idle reset ends the PPP session and reestablishes it, to prevent the carrier network from dropping an inactive call. The default is 1440 seconds (24 minutes). This value is also known as the “Inactivity timeout” in the Web user interface’s “Mobile Settings.”

session time

The duration of the current PPP session. To display total system uptime, issue a “display uptime” command.

rx idle time tx idle time

The amount of time since data was last received (rx)/or transmitted (tx) by the Digi device.

34 Chapter 2 Command Descriptions