Digi 90000566_H manual Set accesscontrol, Options Enabled=onoff, Off, Autoaddsubnets=onoff

set accesscontrol

set accesscontrol

Devices	This command is supported in Digi Cellular Family products only.
supported
Purpose	Used to specify information that limits network access to this device, or
	display current access-control settings. For the Digi Connect WAN, the
	access-control settings also limit routing of packets through the device.
Required	For Digi Connect products with two or more users, to use this command,
permissions	permissions must be set to one of the following:
	• For a user to display the access control settings:
	“set permissions s-accesscontrol=read”
	• For a user to display and set access control settings:
	“set permissions s-accesscontrol=rw”
Syntax	Configure access control settings
	set accesscontrol [enabled={onoff}] [autoaddsubnets={onoff}]
	[addrip[1-64]=ipaddress] [subnip[1-32]=ipaddress]
	[subnmask[1-32]=mask]
	Display current access-control settings
	set accesscontrol
Options	enabled={onoff}
	Used to enable access control. Care must be used with this command
	because improper settings can render this device inaccessible from the
	network. Specifically, setting this option to “on” with no “addrip” option
	values specified will disable all access.
	on
	Enables access control.
	off
	Disables access control.
	autoaddsubnets={onoff}
	Used to enable the automatic adding of subnets and subnet masks to this
	table. The IP subnets for the device server's network interfaces (Ethernet
	and PPP), may be automatically added to the table. This permits access
	by all IP sources on the device server's networks, without having to
	explicitly identify either the subnet IP addresses (and netmasks) or
	individual IP addresses.
	on
	Enables automatic adding of subnets and subnet masks.
	off
	Disables automatic adding of subnets and subnet masks.
	addrip[1-64]=ipaddress
	Used to specify up to 64 individual IP addresses that are allowed to
	access this device.

68 Chapter 2 Command Descriptions