Digi 90000566_H Set dhcpserver set dhcpserver, Dhcp server supports a single subnetwork scope

set dhcpserver set dhcpserver

Devices	This command is supported in Digi Cellular Family products only.
supported
Purpose	Configures the DHCP server settings for the Digi Connect product. A
	DHCP server allows other devices or hosts on the same local network as
	the Digi Connect product to be assigned dynamic IP addresses. This
	DHCP server supports a single subnetwork scope.
	The only DHCP server scope currently supported in Digi Connect firmware
	is for the “eth0” interface. That, the firmware serves IP addresses to DHCP
	clients on the Ethernet side of the Digi Connect product only, and not the
	cellular side, which is handled through Point-to-Point Protocol (PPP)
	instead.
	The DHCP server operates only if the Digi Connect product is configured to
	use static IP address configuration. For information on how to configure
	static IP settings, see "set network" on page 149 and the help for the Web
	user interface’s Network Configuration settings.
	Once configured, the DHCP server is managed through the “dhcpserver”
	command. See "dhcpserver" on page 23.
Required	For Digi Connect products with two or more users, to use this command,
permissions	permissions must be set to one of the following:
	• For a user to display DHCP server settings: “set permissions
	s-dhcpserver=read”
	• For a user to display and set DHCP server settings: “set permissions
	s-dhcpserver=rw”
	See "set permissions" on page 157 for details on setting user permissions
	for commands.
Syntax	Configure the DHCP server: basic settings
	The “item” option must be specified on every instance of a “set dhcpserver”
	command. The “item” option specifies the configuration settings to which
	the command will be applied. To enable a scope, or a reservation or
	exclusion entry within a scope, all of its parameters must be specified and
	valid. A scope or entry can be enabled only if it is completely valid.
	set dhcpserver item={scopereservationexclusion}
	[action={setrevert}]

96 Chapter 2 Command Descriptions