Digi 90000566_H manual Guide

	Quick Reference for Configuring Features
Feature/Task	Commands
IP Forwarding and Network Address Translation	"set forwarding" on page 109.
(NAT)	"set nat" on page 146.
IP pass-through	"set passthrough" on page 153
Mobile (Cellular) features:
• Provisioning CDMA cellular modules	To display existing provisioning parameters:
	“display provisioning” -- see "display" on page 27
	To provision the CDMA module: "provision" on page 53
• Mobile service provider and connection	The only mobile connection setting that can be set from
settings	the command line is the inactivity timeout,
	(“set pppoutbound (rx_idle_timeout=timeout.)
	The Inactivity timeout specifies the time, in seconds, after
	which if no data has received over the link, the mobile
	connection will be disconnected and re-established.
	"set pppoutbound" on page 166.
• SureLink™ Settings	"set surelink" on page 202.
Multiple Electrical Interface (MEI)	"set switches" on page 208
Point to Point Protocol (PPP)	"set pppoutbound" on page 166.
Port buffering	"display buffers" on page 37.
	"set buffer" on page 90.
Port profiles: sets of preconfigured serial-port	"set profile" on page 172.
settings for a particular use
Python® program storage and execution on Digi	To learn about the Python programming language and
devices	writing programs: see the Digi Python Programming
	Guide.
	To configure Python programs to execute when the Digi
	device boots: "set python" on page 183.
	To manually execute a Python program from the command
	line: "python" on page 58.
RCI over Serial	"set rciserial" on page 184.
RealPort (COM port redirection) configuration	"set realport" on page 185.
	See also the RealPort Installation Guide.
Remote access through VNC (Virtual Network	"set vncclient" on page 226.
Computing) protocol
Remote login (rlogin)	"rlogin" on page 66.
Reverting configuration settings	"revert" on page 61.
RTS Toggle	"set rtstoggle" on page 187.

Chapter 1 Introduction 9