Digi 90000566_H manual Set user set user, Or show user, Groups, Disassociate a user from a group

set user set user

Devices	This command is supported in all Digi Connect products.
supported
Purpose	Used to:
	• Add users for access to a Digi Connect device. The number of users
	that can be defined varies by Digi Connect device. To determine the
	number of users allowed for your Digi Connect device, enter “set user”
	or “show user”.
	• Associate a user with a group. A user can be associated with up to two
	groups.
	• Disassociate a user from a group.
	• Remove users.
	• Change user configuration attributes.
	• Display user configuration attributes.
	• Load an SSH public key, and, for single-user model products, unload a
	public key.
Required	For Digi Connect products with two or more users, to use this command,
permissions	permissions must be set to one of the following:
	• For a user to display user configuration attributes:
	“set permissions s-user=read”
	• For a user to display and set user configuration attributes:
	“set permissions s-user=rw”
	See "set permissions" on page 157 for details on setting user permissions
	for commands.
	Default permissions for a new user
	When a new user is created, it is given a set of default permissions. Once a
	user is created, an administrator can adjust permissions up or down as
	needed. Default permissions for a new user are as follows. For more
	information on user permissions, see "set permissions" on page 157.
	• none: for backup, boot, connect, display, buffers, kill, s-alarm, s-gpio,
	s-permissions, s-pmodem, s-rciserial, s-snmp, status, webui, filesys,
	s-idle, s-panic, revert-all, s-trace, s-wlan, s-menu, s-profile
	• execute: For reconnect, rlogin, telnet, who, ping.
	• read: access, s-ethernet, s-group, s-network, s-serial, s-service,
	s-system, s-trane, s-user
	• r-self: autoconnect, rtstoggle, tcpserial, udpserial
	• rw-self: newpass

220 Chapter 2 Command Descriptions