Interface Configurations | ADTRAN 550 specification

Chapter 11. Dial Plan

PATTERN

NUMBER TYPE

AUTOMATIC

ROUTEBACK

REJECTION

GLOBAL TONE TYPE

Modifies an entry when you press Enter (MAX 40). A pattern for a normal long distance call, for example, would be 1+(NXX) NXX - XXXX. Note that the symbols ( ), +, -, and space are not required and are only used to improve the readability of this example.

Lists valid selections when you press Enter. Selections include LOCAL, NA-

TIONAL, INTERNATIONAL, PRIVATE, and UNKNOWN.

Write security: 1; Read security: 5

When enabled, AUTOMATIC ROUTEBACK REJECTION prevents calls entering through network termination interfaces from being forwarded out another network interface. Such an event could happen if an incoming call specifies a number that has no endpoint configured to accept it and another network interface has a call acceptance entry which could accept it (such as $).With- out automatic rejection, such a call would be forwarded back to the net- work. The network would in turn resend the call to the unit until all incoming resources are consumed.

Use extreme caution when disabling AUTOMATIC ROUTEBACK

REJECTION.

Write security: 1; Read security: 5

Specifies the dialing digit tone encoding to be used throughout the entire system. DTMF (dual-tone-multifrequency) is currently the only available option.

INTERFACE CONFIGURATIONS

This section describes Dial Plan NETWORK TERMINATION and USER TERMINA-

TION configuration settings for the following modules.

•Dual T1/PRI Module: Network Termination/PRI on page 11-11

•Dual T1/PRI Module: Network Termination/RBS on page 11-14

•Dual T1/PRI Module: User Termination/PRI on page 11-17

•Dual T1/PRI Module: User Termination/RBS on page 11-20

•Dual Nx56/64 Module: User Termination on page 11-22

•Quad BRI/U Module: Network Termination on page 11-24

•Quad BRI/U Module: User Termination on page 11-25

Configuration descriptions for the Dual T1/PRI Module also apply to the T1 Network Interface.

11-10

ATLAS 550 User Manual

61200305L1-1

Image 152

ADTRAN 550 user manual Interface Configurations, Automatic Routeback Rejection Global Tone Type

Contents

Atlas Trademarks Service Type REN/SOC FIC Usoc Affidavit Requirements for Connection to Digital Services Page Canadian Equipment Limitations About this Manual Introduction Getting StartedReference Information Working with the Atlas Keyboard Commands Notations and Conventions Menu Items Limited Product Warranty Additional Warranty InformationPage Table of Contents Chapter Using the Front Panel 61200305L1-1 Xiii Chapter Module Terminal Menus Modules Menu T1Network Interface Module Chapter Router Dedicated Maps 10-1 Dial Plan 11-1 61200305L1-1 Xix Table of Contents 12-1 Xmodem CRC Appendix B OSI Model and Frame Relay Technology Overview Table of Contents Xxiv List of Figures List of Figures 61200305L1-1 Xxvii List of Figures Xxviii List of Tables List of Tables Introduction Product Overview Access Router Frame Relay Access Switch Frame Relay Circuit Router Dedicated and Switched Connection Maps in a Single Platform Digital Access Cross-Connect System DacsAdditional Applications WAN Overbooking Atlas 550 Features Switched Connection Maps TestingDedicated Connection Maps Performance Monitoring Inspecting the Adtran Shipment InstallationContents of Adtran Shipments Grounding Instructions Reviewing the Rear Panel Design Supplying Power to the UnitMounting Options PIN Name Description Control/Chain In PortControl/Chain In Pinout Control/Chain Out Port Ethernet ConnectionControl/Chain Out Pinout Ethernet Pinout Alarm Relay Connection External Alarm Relay Monitor ConnectionAlarm Relay Connector Pinout Pin Name Description Network RJ-48C Pinout External Relay Monitor Connector PinoutNetwork Connection Test Interface Frame Relay SpecificationsNetwork Interface 15-pin Male D-connector Pinout Option Slots IP Router SpecificationsInstalling Option Modules Installation Using the Terminal Menus Using VT-100 Terminal EmulationOperation Overview Instructions for Defining the IP Address Step Action Using Telnet Starting a Telnet Session Operation Using the Front Panel ACO Switch Craft Port Pinout Craft PortFront Panel Leds Feature Description Controller Status LEDs ACO SwitchAtlas 550 Front Panel Description Network Module LEDs For these LEDs This color light Indicates that Power Atlas 550 LEDsEthernet Remote Module Online Module Test Using the Front Panel Viewing the Menus Navigating the Terminal MenusTerminal Menus Window Window Pane Navigation Menu PathWindow Panes Additional Terminal Menu Window Features Navigating Using the Keyboard Keys Extended Help Moving through the Menus Session Management KeystrokesTo do this Press this key To do this Press this Configuration Keystrokes Getting Help System Control Terminal Menus To do this Go to this menu Password Security Levels Security LevelsSystem Info Rights Startup Mode Current TIME/DATE Installed MemorySystem Location System Contact System Status Menu Event LOG Clear System Event LOG Ethernet Port S Tatus Resource Usage Ration Chain Port Signal Leads ZeroChain Port TX Bytes Primary Timing Source System ConfigBackup Timing Source MAX Telnet Sessions Chain Port Snmp AccessMbps Snmp Current ES Thrsh Total PCV Thrsh D4 Total PCV Thrsh ESF Syslog Setup Event Logging Deleting Passwords Access PasswordsInstructions for Adding/Deleting Passwords Licenses Alarm Relay Reset Alarm Relay Threshold System Utility Menu Available update options vary depending on whether you Indicates the slot number Tftp Server Update StatusConfig Transfer Configuration file, reboots, then restarts using the new View Self-test Log DSP RAM RTC RAMTDM RAM Dram Reboot System Factory Default System Module Terminal Menus Modules Alarm SLTType Menu REV Modules Menu T1Network Interface ModuleStatus LOS REDYellow DS0 a Larm Displays the A/B signaling bits for Rx and Tx DS0s DS0 a Larms TX Prms LBO LOC LB Module Terminal Menus Packet Manager Packet Manager Menus Packet Manager Menu Tree Packet Endpnts Frame Relay Statistics LMIPerformance Tbop Statistics Dlci Fecn Count ConfigBecn Count Operates in NNI mode QOS Dlci State PVCCIR Sublinks Example Dlci QOS Usage Characters Character Description Endpnts Sort Results MN/AV/MX DLYEndpnt Count Protocol Packet CnctsSublink Enable IQ Stats Port EnablesCncts Sort Frame Relay IQ View IQ Statistics INK Poll CRC Error PVC IA Time RX FecnTX Fecn RX Becn RX CR TX CR Packet Manager Router Router IP Menu Tree IP Menus Static Routes ARP Cache Routes Interfaces Subnet Mask FAR-END Address Only advertises routes not learned through this interface Port Name EthernetProxy ARP Ping Reset Stats StatisticsTX Stats START/STOP ReasmTimeout Name Description ForwDatagramsInUnknownProtos InDiscards Icmp Icmp Statistics Name Description OutRedirects OutEchosOutEchoReps OutTimestamps IP Fast Cache Statistics UDP StatisticsIP Fast Cache UDP Port UDP RelayRelay Table Router Dedicated Maps Dedicated Maps Menu Tree Using Dedicated Maps with Frame Relay Activate MAPCurrent MAP Auto Create / Edit Maps MAP NameConnects From S LT To S LT/S RT/PEP1ST DS0 DSO Rate T1 Trouble Code Service only applies to non-RBS T1s SIG RBSActivate Time Enbl DAY Example 1 Setting Trunk Conditioning Example 2 Creating a Dedicated MapT1-A T1-B PBX Atlas External Router Configuring the Ports for Example Instructions for Configuring the Ports Instructions for Defining the Data Connections Data Connections Instructions for Defining Voice Connections DS0s Completed Dedicated Map for Example 10-12 61200305L1-1 Dial Plan Dial Plan Menu Dial Plan Menu Tree OUT#ACCEPT Network TermSLOT/SVC RC ID 5 = Ifce Config Data 64KData 56K 64K and Data 56K SRC ID User TermIN#ACCEPT Write security 3 Read security $ rejects all long distance calls, but only for this User Global Param Interface Configurations Automatic Routeback Rejection Global Tone Type Dual T1/PRI Module Network TERMINATION/PRI Strip MSD Network Specific Facility Voice Data Called Digits Transferred Prefix Outgoing Caller Dual T1/PRI Module Network TERMINATION/RBS Source ID DS0S Available FGD TX SequenceFGD RX Sequence Wink After ANI Digit Suppression Direct Inward Dialing Trunk Number Dual T1/PRI Module User TERMINATION/PRI Network Specific Facility Called Digts Transferred Outgoing Caller Source ID Signaling Method Dual T1/PRI Module User TERMINATION/RBS If Feature Group D is used, did refers only to Dnis digits Did D Igts Dual NX56/64 Module User Termination Source ID Ports Available Number of PortsNumber to Dial Call Type D64, D56 Quad BRI/U Module Network TerminationSpid Number Quad BRI/U Module User Termination Spid List Creating Dial PLANS-EXAMPLES Example 2 Point-to-Point Connection Dial Plan Configuration Understanding Dial Plan ConfigurationsExample 1 Pstn Connection Dial Plan Configuration PORT/PEP Connecting Packet Endpoints in Frame RelayPktendpt Port/PEP Menu Call Routing Table for Routing Using Incoming Number Pktvoice ORT/PEP 12. Interface Configuration Network Termination Did Prefix Menus for Network TerminationDid Digits Menus for User Termination Did D Igits Xmodem Firmware Updates Updating Firmware Updating Firmware using Xmodem Instructions for Updating Firmware Using Xmodem Instructions for Updating Firmware Using Xmodem Step Action Tftp Firmware UpdatesUpdating Firmware using Tftp Step Action Using a Telnet program, log in to Atlas YPE when updating a LL M Odules of a T YPE in the AtlasFilename of the update file that was recorded earlier Current firmware update or any errors encountered during Tftp Upload Messages Message MeaningComplete Upload Incomplete Upload 12-6 61200305L1-1 Snmp Management Snmp OverviewSnmp Basic Components MIB Trap Destination List Configuring a Trap Destination List via the Terminal MenuSnmp Traps Disabling Trap Generating Events Standard TrapsStandard Snmp Traps Trap Name Severity Description DS1 Traps Current Alert Snmp Traps DS1 Snmp Current Alert TrapsCurrent Alert Severity Description Total Alert Snmp Traps Total Alert Traps Total Alert Severity DescriptionClearing DS1 Alert Traps Far End Alert Traps Adtran Utilities Syslog Host Daemon SysLog GUI Atlas 550 SysLog Host GUI Monitor Menu Bar File Help DisplayLOG Files Telnet Utility Telnet Menu Tree Session Connect Edit Options Capture Contents VT-100 UtilityIP Status About Edit Port Tftp Server Utility Colors Enable DisableServer Abort Status Field Meter FieldLOG Field Print LOG Unsuccessful Transfer Saving the Current Configuration to a Tftp ServerInstructions for Saving the Current Configuration Retrieving the Configuration from a Tftp Server Request Appendix a System Event Logging Table A-1. System Event Event Category Console Log String Table A-2. Switchboard Events Table A-3. Nx 56/64 Events Table A-4. T1 Events Table A-6. Isdn Events Table A-4. T1 Events Category Console Log StringTable A-5. Ethernet Events Isdn Cause Codes Table A-7. Isdn Cause Code Events Category Cause Code LOG Entries Table A-8. Cause Code Log Entry Location Designations Appendix A. System Event Logging Table B-1. Seven-Layer OSI Model Appendix B OSI Model and Frame Relay Technology OverviewOSI Model Example 1 OSI Model Related to Process of Mailing a Letter Send Process Receive Process Frame Relay Virtual Circuits Figure B-2. Frame Relay Network using Virtual Circuits Figure B-1. Three Virtual Circuits in One Physical Circuit Local Management Interface LMI Data Link Connection Identifier DlciUser-to-Network Interface Committed Information Rate CIR Table B-2. LMI Group of Four Dlci AssignmentsUse Annex a and Annex D Managing Network Congestion Figure B-4. Network Congestion and Flow Control Tbop Figure C-1. Atlas to Support Packet Data Configuration Appendix C Frame Relay Examples Figure C-3. Menu for Creating Packet Endpoints Example IP Routing Network-External Routers Figure C-9. Menu for Configuring Packet Endpoints 1 Sublinks Figure C-14. Menu for Creating Packet Endpoints Figure C-16. Menu for Connecting Packet Endpoints Step Figure C-18. Public Frame Relay Network Step Figure C-22. Menu for Configuring Dial Plan Step Example 5 Private Frame Relay Network-Packet Voice Figure C-25. Menu for Creating Packet Endpoints Figure C-29. Connecting PBX DS0 to Frame Relay Endpoint Figure C-30. Connecting FR Endpoint to FR Private Network Figure D-1. Atlas 550 Configured for the Router Option Appendix D Router Examples Example IP Routing NETWORK-ATLAS AS the CENTRAL-SITE Router Figure D-3. Creating Packet Endpoint Figure D-4. Creating Sublinks Appendix D. Router Examples Appendix E Troubleshooting Power-up Self Test Fails Cannot pass data from T1 interface to V.35 port Frame relay link is down Appendix E. Troubleshooting Appendix F Acronyms and Abbreviations PBX Glossary Law Becn Dhcp Fecn Hdlc LEC NNI PCM SNA UDP Appendix G. Glossary Appendix G. Glossary Numerics SymbolsIndex Index-2 61200305L1-1 Index-3 Index-4 61200305L1-1 Index-5 Index-6 61200305L1-1 Index-7 Index Index-8 Repair and Return Pre-Sales Inquiries and Applications SupportPost-Sale Support