
Chapter 11. Dial Plan
| Figure | |
PKTVOICE | The ATLAS 550 provides the same level of capability for | |
| voice as originally provided for | |
| IFCE CONFIGURATION (under DIAL PLAN > USER TERM or NETWORK TERM) sets | |
| configuration parameters for the endpoint. These parameters vary by the | |
| type of port selected. The following section describes the configuration op- | |
| tions available for | |
| The first step in configuring the DIAL PLAN for packet voice is to select | |
| NETWORK TERM or USER TERM. Refer to Connecting Packet Endpoints in Frame | |
| Relay on page | |
| TERM. (See also Menus for Network Termination on page | |
| User Termination on page | |
| fields become available. These fields are discussed in the following sections. | |
|
|
|
|
|
|
| Figure |
SLOT/SVC | Write Security: 3; Read Security: 5 |
| Select PKTVOICE as the service. |
PORT/PEP | Write Security: 3; Read Security: 5 |
| Select the port/packet endpoint that you want to configure. |
SIG | Not used for packet voice. |
IN#ACCEPT | Write Security: 3; Read Security: 5 |
| Configured as defined in In#Accept on page |
OUT#REJ | Write Security: 3; Read Security: 5 |
| Configured as defined in Out#Rej on page |
IFCE CONFIG | Write Security: 3; Read Security: 5 |
| Provides interface configuration parameters (see Figure |
ATLAS 550 User Manual |