Chapter 11. Dial Plan
SOURCE ID | Write security: 3; Read security: 5 |
| Simplifies the creation of a DIAL PLAN in applications where the criterion for |
| switching calls to a certain endpoint is a function of which endpoint origi- |
| nated the call. |
| • Default value = 0. The default ID for all endpoints is 0 and all accept |
| numbers is 0. With default values, all calls are routed based only on the |
| dialed number. |
| • Multiple endpoints can have the same SOURCE ID. |
| • When creating the CALL ACCEPT list, specify a SOURCE ID(s) as well as a |
| dialed number or range of dialed numbers to accept. |
| Example: |
| An application requires that all calls that originate from Port 1 of the ATLAS |
| 550 in Slot 1 be switched to Port 2 of that same module. Assign a unique |
| Source ID (e.g. 7) to Port 1 of the module, and then configure Port 2 to only |
| accept calls from that unique Source ID (7). |
SWAP ANI/DNIS | Write security: 3; Read security: 5 |
| Swaps the ANI and DNIS numbers received from the network. ANI (Auto- |
| matic Number Identification) is the billing number of the calling party, and |
| DNIS (Dialed Number Identification Service) is the called party number. |
|
|
| With this swap, the ATLAS 550 switchboard uses ANI to route the |
| call. The accept number in the Dial Plan must use the ANI number, |
| not the DNIS number. |
|
|
DUAL T1/PRI MODULE: NETWORK TERMINATION/RBS
| When you are working in the network termination section of the DIAL PLAN |
| menu, when SLT is defined as |
| lowing interface configuration options are available: |
FIRST DS0 | Write security: 3; Read security: 5 |
| Defines to the ATLAS 550 the first DS0 for this endpoint.The ATLAS 550 |
| uses DS0s, starting with this selection, to send and receive calls to and from |
| the network (PSTN). The outgoing calls which are allowed or restricted |
| over these DS0s are set by the OUTGOING CALL ACCEPT and REJECT NUM- |
| BERS (discussed in First DS0 on page |
NUMBER OF DS0S | Write security: 3; Read security: 5 |
| Specifies the number of DS0s the ATLAS 550 uses for this endpoint. |
ATLAS 550 User Manual |
