ADTRAN 550 user manual Configuring the Ports for Example, Instructions for Configuring the Ports

Chapter 10. Dedicated Maps

Configuring the Ports for Example 2

Complete the steps outlined in the following Step/Action table to configure the various ports to match the framing parameters of the T1 line provided by the telco. (Also see Table 10-2.)

	Instructions for Configuring the Ports
Step	Action
1	Navigate to MODULES.
2	Select NTW1 (a T1/PRI network interface).
3	Set the line framing parameters by selecting the corresponding
	MENU / CONFIGURATION / FRAME / ESF.
4	Navigate to PRT and press C to copy this configuration information
	for use with additional ports.
	Navigate back to NTW2 and move to its corresponding MENU /
5	CONFIGURATION / PRT. Paste the information copied in step 3 here
	by pressing P. Press Y to confirm paste.
	Assign a T1/PRI card to Slot 1. Paste the information copied in step
6	3 by moving to the corresponding MENU / CONFIGURATION / PRT
	and pressing P. Press Y to confirm paste (see Figure 10-6 on
	page 10-9).
7	Assign Dual Nx 56/64 cards (V35Nx-2) to Slots 2 and 3.

Figure 10-6. T1/PRI Configuration Menu for Example 2

Defining the Connections for Example 2

Define the connections by completing the following Step/Action tables. Make the data connections first and then make the voice connections. Refer to Table 10-2 on page 10-8 and Figure 10-7 as you define the connec- tions.

61200305L1-1 ATLAS 550 User Manual 10-9