Chapter 6. System Control Terminal Menus
RESTART AT SPECIFIED DATE AND TIME
Lets you specify a date and time to automatically restart the updated mod- ule. (When you select this option, a new field called RESTART DATE AND TIME displays below the current field.)
RESTART DATE AND TIME
Write security: 1; Read security: 5
Defines the date and time to restart the sys- tem. Enter the time using a
(i.e., 23:25:30 for 11 PM, 25 minutes, 30 seconds). Enter the date in mm-
RESTART AT SPECIFIED DATE AND TIME is only available for the
System Controller— not for modules residing in expansion slots, since they are unable to maintain normal operation during the update process.
CURRENTRead security: 5
UPDATE STATUS Indicates progress or problems encountered during the current update pro- cess. The field displays IDLE if no update is in progress or when the update is successfully completed. At the end of a successful update, the contents of this field are copied into PREVIOUS UPDATE STATUS.
If you are updating several modules at the same time (if MODULE SLOT is set to ALL MODULES OF A TYPE), this option displays [+], indicating this field con- tains submenu items. The following submenus display:
SLT | Indicates the slot number. |
TYPE | Defines the type of module for each slot. |
CURRENT | Indicates the status of the current update. |
STATUS |
|
PREVIOUS | Indicates the status of the previous update. |
STATUS |
|
PREVIOUS TIME Indicates the time of the previous update.
During the TFTP upload process, various status messages are provided in CURRENT UPDATE STATUS (see Table
PREVIOUSRead security: 5
UPDATE STATUS Displays the status of the previous update, after selecting a module slot. If a firmware update has not been attempted for a particular slot, this field reads Has not been attempted. Following a successful update, the field reads Module Update Complete. If an update was unsuccessful, the appropriate error message displays.
ATLAS 550 User Manual |
