Agilent Technologies S GSM, 8922M Controls, Marker, Meas Reset, Time/div, Vert/div, Vert Offset

Screens

Oscilloscope, Main Controls

2. Controls	This field selects the set of oscilloscope controls.
	Choices	Main
		Trigger
		Marker

3. Marker	This field displays the signal level at the current marker position. The units-of-
	measure for this field are determined by the AF Anl In selection.
	See Also		Keys: ON/OFF, HI LIMIT, LO LIMIT, REF SET, AVG, Units
4. Meas Reset	Selecting Meas Reset will erase any accumulated measurements used for calculating
	a final result, and re-start the measurement process for the following functions:
	•	HI LIMIT
	•	LO LIMIT
	•	AVG
	See Also		Keys: HI LIMIT, LO LIMIT, AVG
5. Time/div	This field selects the horizontal sweep time per division.
	Choices		200, 100, 50, 20, 10, 5, 2, or 1 ms
			500, 200, 100, 50, 20, 10, 5, 2, or 1 μs
6. Vert/div	This field, vertical sensitivity, sets the vertical amplitude per division. The units-of-
	measure for this field are determined by the AF Anl In selection. When selecting
	upper or lower limits of vertical sensitivity, an UNCAL message appears on the
	display. This message indicates that the scope is operating out with calibrated
	ranges.
	See Also		Screens: Audio, (AF Anl In)
7. Vert Offset	This field moves the displayed signal trace above or below the oscilloscope’s fixed
	centerline.

4-76