Agilent Technologies S GSM, 8922M manual System, Information sent, Received, End Call, Flush Log

	APPENDIX A
	How to Obtain a Protocol Log
System	Once the call is up, then System Information messages will begin to appear for the
Information sent	entire duration of the call. Since there is only one ’BTS’ there will be no handovers
and received	during the call. The System Information messages contain power measurements and
	bit error indications for both uplink and downlink directions.
End Call	To end the call, on the Mobile Station handset, press ’END’. At this point the call will
	drop. There may not have been enough messages on the Agilent 8922M to fill the
	cache for the last messages to be put out to the HP/Agilent 37900D.
Flush Log	To see the last protocol messages from the Mobile Station handset, go to the logging
	screen on the Agilent 8922M.
	Select Flush Log
	Press ’S’ on the HP/Agilent 37900D to stop logging, and Quit (Press ’Q’) to get
	back to the MONITOR MODE menu.
	Refer to the HP/Agilent 37900D Monitor Guide for detailed information on using
	the HP/Agilent 37900D Signaling Test Set.

A-10