Agilent Technologies S GSM, 8922M manual Mobile phone

	Making Measurements
	ACTIVE CELL
	There may be many reasons for the measured level not being close to the expected
	level. The two most likely are that, either, the mobile phone is not operating
	correctly, or, there is some power loss between the Agilent 8922M/S RF IN/OUT
	connector and the mobile phone. If you suspect it is the second case, you can
	compensate the Agilent 8922M/S generator settings and measurement results for
	external losses or gains. The compensation is carried out in the CONFIGURE screen
	which is accessed using the CONFIG field on the bottom right-hand side of the
	screen, (6), see Figure 2-2 on page 2-6. Refer to Chapter 4, Screens for further
	information.
	Timeslot To change the timeslot, highlight the field and enter a new timeslot value
	from the keypad. The timeslots can vary from 2 to 6. (Timeslots 0, 1, and 7 are
	reserved for maintaining communication between the Agilent 8922M/S and the
	mobile phone.)
NOTE	While the Active Cell is selected, the three MOBILE PHONE parameters are also
	available on the bottom right-hand side of all measurement screens. This provides
	control of the mobile phone during measurements.

2-8