Agilent Technologies S GSM, 8922M manual 17 on

Instrument BASIC

Programming and Using the TESTS Subsystem

1 Select the front-panel TESTS key, and then the Test Function Edit Cnfg. A configuration screen similar to that shown in Figure 8-17 on page 8-37 appears.

2Select the Calling Name field and enter the instrument’s name in upper-case letters. For example, PRINTER, POWER SUPPLY, DATA COLLECTION, and so forth. Refer to item (1) in Figure 8-17 on page 8-37.

3Select the Model field and enter the instrument’s model number. There is no specific syntax for entering model numbers into this field. Refer to item (2) in Figure 8-17 on page 8-37.

4Select the Addr (address) field and turn the knob to enter the last two digits of the instrument’s GPIB address. Refer to item (3) in Figure 8-17 on page 8-37. (The RS-232 address must be 9, and the Data Collection address must be 1.)

5Select the Options field (refer to item (4) in Figure 8-17 on page 8-37) and enter the instrument’s option number(s) if any. This field may be left blank, or otherwise may include other calling name options, for example:

Printer options –LN=#,START,END

Where # is the number of lines on each page.

Where START causes a form feed at the start of each printout. Where END causes a form feed at the end of each printout.

Data collection option –NN

Where NN is the number of records (file size) for the mass- storage location where data will be collected on disk or mem- ory card. The default record size is “80”.

6Press the Insrt Ins field or Delet Ins field as needed or turn the knob to insert or delete as many instruments as needed. Refer to item (5) in

Figure 8-17 on page 8-37.

8-36