Agilent Technologies S GSM, 8922M manual This field is not featured in the Agilent 8922S

Screens

Bit Error 2

NOTE		This field is not featured in the Agilent 8922S.
2.	Amplitude	This field changes the RF generator amplitude. It is a duplicate of the RF generator’s
		Amplitude field on the RF Generator/RF Analyzer screen.
		See Also	Screens: RF Generator/RF Analyzer (RF Generator).
3.	Atten Hold	This field turns the attenuator hold on or off.
4/5. BE Ratio/BE		These fields select how bit errors will be displayed for both the Intermediate and
	Count	Completed results.
		Choices	Bit Error displays the bit errors/count per measurement.
			Bit Count calculates and displays the ratio of bit errors counted to
			the total number of bits measured (depends on measurement type).
		Field (4) displays the final result of the measurement, field (5) displays a running
		total of the bit errors.
6. Meas Num		Use this field to define and display measurements 1 or 3. The right side of the screen
		allows access to measurements 2 or 4. Refer to 16 for further information.
7.	Bits Tested	This field displays the number of bits that have been tested during a measurement
	(Intermediate)	that is currently running. This number includes only bits that are tested by the
		selected measurement type.
8.	Bits Tested	This field displays the number of bits that were tested during the last fully completed
	(Completed)	test.
		Bit error tests may extend beyond the number entered in the “Bits To Test” field so
		that the last speech frame may be completed.
9.	Bits To Test	This field selects the number of bits which will be tested. This number includes only
		bits that are tested by the selected measurement type.

10.CRC or FE These fields determine what data will be displayed.

Choices	CRC displays cyclic-redundancy-check (CRC) errors.
	FE displays frame erasures.
See Also	Keys: ON/OFF, LO LIMIT, HI LIMIT, REF SET, AVG, Units

4-12