Compaq AP500 manual Removing a Symbios Wide Ultra2 PCI Scsi Controller

3-15

Removing a Symbios Wide Ultra2 PCI SCSI Controller

NOTE: For best performance, do not mix Wide-Ultra and Wide Ultra2 SCSI hard drives on the same SCSI cable or the same channel.

To remove a Wide Ultra2 SCSI Controller:

1.Perform the service preparations shown on page 3-2, then lay the workstation on its side.

2.Remove the following components:

❏Workstation feet

❏Side access panel

3.Remove the I/O bracket assembly.

4.Disconnect the SCSI cable from the controller.

5.Remove the retaining screw that holds the controller in place.

6.Remove the controller.

To replace the controller, reverse the above procedure.

Compaq Professional Workstation AP500 Maintenance and Service Guide