Compaq AP500 Primary Processor Power Module Cable Insulator, 50Removal and Replacement Procedures

3-50Removal and Replacement Procedures

Primary Processor Power Module Cable Insulator

A cable insulator reduces damage to cables routed over the power module. If you are replacing the primary processor module, you must first remove the cable insulator from the module and place it on the new power processor module.

To remove the cable insulator:

1.Perform the service preparations shown on page 3-2, then lay the workstation on its side.

2.Remove the following components:

❏Workstation feet

❏Side access panel

❏I/O bracket assembly

❏Primary power processor module

WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching.

3. Remove the cable insulator from the primary processor power module.

Figure 3-48. Removing the cable insulator

To reinstall the cable insulator, reverse the above procedure.

NOTE: Make sure you firmly press the primary processor power module and cable insulator into the primary power module connector. Then, secure the two latches on the connector.