3-54Removal and Replacement Procedures

Power Switch Cable Assembly

The power switch cable assembly can be replaced without removing the power supply. To remove the power switch cable assembly:

1.Perform the service preparations shown on page 3-2.

2.Remove the following components:

Side access panel

Front bezel

CD-ROM drive or DVD-ROM drive (if installed)

3.Disconnect the power switch cable from the system board.

4.Remove the screws that keep the power switch cable assembly in place.

5.Remove the crown from the power switch cable assembly.

6.Gently slide the cable through the CD-ROM drive bay opening.

7.Remove the power switch cable assembly from the chassis.

Figure 3-50. Removing the power switch cable assembly

To replace the power switch cable assembly, reverse the above procedure.

Page 74
Image 74
Compaq AP500 manual Power Switch Cable Assembly, 54Removal and Replacement Procedures