
3-52 Removal and Replacement Procedures
Installing the Battery
CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning these procedures, make sure you are properly grounded. See “Electrostatic Discharge Information” in Chapter 2 for more information.
To install an external
1.Perform the service preparations shown on page
2.Remove the following components:
❏Workstation feet
❏Side access panel
❏I/O bracket assembly
3.Remove the backing from the adhesive on the
4.Connect the battery connector to pins 1 - 4 on J5 B and move the jumper from pins 6 and
7 to pins 5 and 6 .
2
1
1
1