Compaq AP500 manual 22Diagnostic Tools, Computer Setup Features, Task Computer Setup Selection

4-22Diagnostic Tools

Computer Setup Features Continued

Task Computer Setup Selection

Set the printer mode (flexible/standard).

Set the Num Lock state at power-on.

Disable energy saver mode.

Select timeout values.

NOTE: These selections appear only the when energy saver mode is set (default).

Click Built-in Devices, then click Communications. Under Parallel Port, select the appropriate Bi-directional Port.

Click Built-in Devices, then click Input Devices. Under Keyboard, turn on Num Lock State At Power-on.

Click Built-in Devices, then click Power Management. Select Energy Saver Disabled.

Click Built-in Devices, then click Power Management. Under Hard Drive and/or Monitor, select the Timeout value.

Enable/disable power LED blink in suspend mode

NOTE: This selection does not appear if the energy saver mode is disabled.

Click Built-in Devices, then click Power Management. Select Blink LED during Energy Saver.

Enable the Power-On Password.

Enable/disable keyboard QuickLock, QuickBlank screen when locked, and QuickLock in energy saver mode.

NOTE: These selections appear only if a Power-On Password is set.

Enable the Setup (administrator) Password.

View current settings of Plug and Play (PnP) devices and set resources for installed boards.

View the currently installed PCI devices and view and/or reconfigure settings (IRQ, I/O, DMA, memory).

Enable/disable the SCSI controller boot order for Compaq SCSI options.

Enable/disable PCI bus mastering, PCI VGA palette snooping, and interrupt sharing.

Restore factory default settings and exit Computer Setup.

Exit Computer Setup without applying or saving any changes.

Save changes to the system configuration and exit Computer Setup.

Click Built-in Devices, then click Security Management. Under Power-On Password, click Set.

Click Built-in Devices, then click Security Management. Under Power-On Password, select the appropriate options.

Click Built-in Devices, then click Security Management. Under Setup Password, select Enable Setup Password.

Click Integrated and Add-in Devices, then click ISA Boards.

Click Integrated and Add-in Devices, then click PCI Boards.

Click Integrated and Add-in Devices, then click PCI Boards. Under SCSI Controller Boot Order, select Enable Boot Order.

Click Integrated and Add-in Devices, then click PCI Boards. Under System Options, select the appropriate options.

Select File, then select Set Defaults and Exit.

Select File, then select Exit Without Saving Changes.

Select File, then select Save Changes and Exit.