Chapter 7 Replacing Consumables
7.4 Replacing the Brake Roller
1
2 If the hopper has been raised, bring it back down to the lower position.
For information on how to adjust the hopper level, refer to "1.7 Setting the Loading Capacity of the Hopper" (page 23).
3 Open the ADF.
For information on how to open the ADF, refer to "1.5 Opening/ Closing the ADF" (page 20).
2Remove the brake roller. Lift the left side of the roller first, then pull out the shaft from left to right.
1
2 | Brake Roller |
|
Be careful not to have your fingers caught when the ADF closes.
4 Remove the brake roller from the scanner. | 5 Install a new brake roller on the scanner. | |
1 Open the roller cover. Lift up the cover from the lower middle. | 1 Install the brake roller. Insert the shaft from the right side to the | |
left. | ||
| ||
| 2 |
1 | Brake Roller |
|
Roller Cover
2 Close the roller cover. Make sure that both ends of the cover are locked firmly.
137