Chapter 1 Scanner Overview

1.8 Stacker Setting

When you perform a scan, the document loaded on the hopper is ejected onto the stacker.

You can stack the documents neatly by using the stacker extension and the stacker side guides as shown in the procedure below.

You can also fix the stacker at certain heights.

How to Guide Documents

1 Adjust the stacker extension to the length of the document, and pull up the paper stop.

Stacker Extension

Paper Stop

zDo not hold the paper stop when you pull out the stacker extension because it may break.

zMake sure that the position of the paper stop is set longer than the document length.

You can align the documents neatly by leaving a small gap between the paper stop and the documents.

Use the paper stop (small) when the document length is short. Lift up the paper stop (small) to about 130 degrees from the stacker level.

Paper Stop (Small)

To scan documents longer than A3 size, pull out the hopper extension and the stacker extension all the way. Also, make sure not to pull up the paper stop.

2 Adjust the stacker side guides to the width of the document.

Stacker Side Guide

Make sure to set the distance between the stacker side guides longer than the document width.

24