Chapter 9 Operational Settings

Specifying an Area Not to Detect Multifeed

3 Select an operation mode and click the [OK] button.

[Intelligent Multifeed Function]

 

 

 

 

Mode

Description

When there is paper of the same size attached to a

 

 

 

 

Manual mode

Stops feeding the documents when a multifeed is

designated location on the page, the scanner can memorize

 

 

detected. You can resume scanning by loading the

the location of the attachment and can be configured not to

 

 

documents back on the hopper. The size and

detect multifeeds for that location. To configure this setting,

 

 

location of the paper attachment are not

 

 

memorized.

you first need to select [Check Overlapping (Ultrasonic)] for

 

 

 

 

Auto mode 1

Memorizes the size and location of the paper

the multifeed detection setting in "Specifying a multifeed

 

 

 

attachment upon resuming the scan when a

detection method [Multifeed]" (page 207) or the scanner

 

 

 

 

multifeed is detected and the document is loaded

driver’s setup dialog box.

 

 

back on the hopper. The memorized pattern is

1 Start up the Software Operation Panel.

 

 

ignored from the next scan.

 

 

 

 

Auto mode 2

Memorizes the size of the paper attachment upon

Refer to "9.1 Starting Up the Software Operation Panel" (page 170).

 

 

resuming the scan when a multifeed is detected

2 From the listing on the left, click [Device Setting 2] J

 

 

and the document is loaded back on the hopper.

 

 

The memorized pattern is ignored from the next

[Intelligent Multifeed Function].

 

 

scan.

z By selecting the [Clear overlap pattern] check box, you can erase the overlapping patterns (length, position) that were memorized in Auto mode.

z You can specify whether to enable or disable the [Scan] button when using Kofax VRS in [Enable Scan button (VRS)].

z By selecting the [Auto-Memorize MF Pattern (only when MF images are displayed)] check box, you can have the multifeed pattern memorized in the window that shows the multifed images.

z In [Remember multifeed pattern at power-off], you can select whether or not to memorize the multifeed pattern upon turning the power off. When [Remember] is selected, you can use the memorized multifeed pattern when the scanner is powered on next.

z This setting can also be configured from the operator panel.

For information about the procedure after this step, refer to "Bypassing Multifeed Detection for a Fixed Format" (page 114).

TOP

Contents

Index

Introduction

Scanner

Overview

How to Load Documents

Configuring the Scan Settings

How to Use the Operator Panel

Various Ways to Scan

Daily Care

Replacing Consumables

Troubleshooting

Operational Settings

Appendix Glossary

213