Setting the Maintenance/Inspection Cycles for the Scanner[Maintenance and Inspection Cycle]
You can specify the cycle of regular maintenance/inspection by a service engineer.
A message for regular maintenance appears when the time specified here elapses after the last time regular maintenance/ inspection was performed. Messages for regular maintenance can be checked in [Information] of the operator panel.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 170).
2 From the listing on the left, click [Device Setting 2] J [Maintenance and Inspection Cycle].
3 Select whether to enable or disable [Maintenance and Inspection Cycle].
When you enable this setting, select a cycle for maintenance/ inspection by a service engineer.
217