Fujitsu FI-6800 rectangular Documents, Scan Settings for Documents with Tabs/Non

Chapter 9 Operational Settings

Scan Settings for Documents with Tabs/Non-	3 Select one from [Document with tab], [Document without
rectangular Documents		tab] or [Non-rectangular document].
[Scan Setting for Document with Tab (Automatic
		Item	Description
Page Size Detection)]
		Document with tab	Scans up to 20 mm off the bottom edge of
For documents with index stickers or index tabs attached on
			the document with a tab.
the end, you can scan the whole document including its
		Document without	Stops the scan when it detects the bottom
attachments with Automatic Page Size Detection.
		tab	edge of the document.
1 Start up the Software Operation Panel.
		Non-rectangular	Scans up to 120 mm off the bottom edge of
		document	the detected document.
Refer to "9.1 Starting Up the Software Operation Panel" (page 170).
			(Not available when connected via SCSI or
2 From the listing on the left, select [Device Setting 2] J			USB Connector 2)
[Scan Setting for Document with Tab (Automatic Page
Size Detection)].		z The scanning speed slows down when you select
		[Document with tab] or [Non-rectangular document].
		z To scan documents with tabs or non-rectangular
		documents, refer to "Loading Documents with Tabs or
		Non-rectangular Documents" (page 43).
		z For information on how to configure Automatic Page
		Size Detection, refer to "Automatically Correcting
		Skewed Document Images" (page 97).
		z When connected via SCSI or USB Connector 2, the
		tab may be missing from the scanned image when a
		document smaller than A5 size is scanned.

TOP

Contents

Index

Introduction

Scanner

Overview

How to Load Documents

Configuring the Scan Settings

How to Use the Operator Panel

Various Ways to Scan

Daily Care

Replacing Consumables

Troubleshooting

Operational Settings

Appendix Glossary

203