Chapter 1 Scanner Overview
1.7 Setting the Loading Capacity of the Hopper
If there are only a few documents, you can set the hopper to a higher position and shorten the time to get to the feeding position.
zTo avoid the risk of jamming your fingers, do not touch the hopper while it is moving up/down.
zDo not place anything on top of the hopper while it is moving. The scanner may be damaged if any object is caught inside.
zTo avoid any contact that may damage the scanner, do not place anything beneath the hopper.
zDo not adjust the hopper height from the operator panel when the hopper is closed, as it may damage the hopper.
This function is only available when [Ready] is displayed on the operator panel LCD.
The hopper level can be set for three different capacities.
Use the operator panel to adjust the height of the hopper. Configure by selecting [10: Hopper Level] in the [Main Menu] of the operator panel.
For more details about the settings, refer to "4.2 Main Menu" (page 65).
When the scanner has just been powered on, it is set to the [4: Lower] position.
[Hopper Level] can also be displayed by shortcut key. To display the [Hopper Level] screen by shortcut key, press the [Eject] button and either [U] or [V] button at the same time when [Ready] is displayed. Change the hopper level by using the [U] or [V] button in [Hopper Level]. Note that the [Hopper Level] screen is not displayed unless the two buttons are pressed simultaneously.
Upper: A maximum of 100 sheets (*1) can be loaded.
Middle: A maximum of 300 sheets (*1) can be loaded.
Lower: A maximum of 500 sheets (*1) can be loaded.
Upper
Middle 
Lower
Menu Function
|
| /Enter |
Send to | Check | Clear |
/Pause |
| /Back |
| Stop |
|
| Scan |
|
*1: For documents with a paper weight of 80 g/m2 (20 lb).
The capacity varies depending on the paper weight of the document. For more details, refer to "2.2 Documents for Scanning" (page 40).
Counter
iMFF Reset Eject
When [Hopper Level] is displayed by shortcut key, the screen returns to [Ready] after a certain period of time. This period of time can be configured in [18: Operation Panel Timeout] of the operator panel.
23