Chapter 4 How to Use the Operator Panel
6 Load the documents on the hopper, start up a scanning application, and perform a scan.
For information about the scanning procedure in ScandAll PRO, refer to "How to Use ScandAll PRO".
DDepending on the number of sheets scanned, it will be displayed as follows:
zWhen you press the [Counter Reset] button, the screen returns to [Doc Count Check Mode] in step 5.
zWhen you press the [Stop] button, it exits [Doc Count Check Mode] and returns to the [Ready] screen.
Sheets | Display | Description |
|
|
|
75 |
| Since the count has been set to |
sheets |
| 100 in step 4, it is |
|
| |
|
| [Count] indicates “25”. |
|
| If you load additional documents |
|
| at this point, you can scan up to |
|
| 25 sheets. |
|
|
|
100 |
| Since the count has been set to |
sheets |
| 100 in step 4, it is +/- 0. |
|
| [=] appears in the top right and |
|
| [Count] indicates “0”. |
|
|
|
110 |
| Since the count has been set to |
sheets |
| 100 in step 4, it is +10 sheets. |
|
| [+] appears in the top right and |
|
| |
|
| [Count] indicates “0”. Scanning |
|
| stops once 100 sheets have been |
|
| scanned. |
zDocuments may not be counted correctly if a multifeed occurs during scanning.
zIn the following cases, the scanning returns to normal from Doc Count Check mode:
-When you only scan the specified pages (selecting [Scan the specified number of pages] in [Scan Settings] of ScandAll PRO)
-When you scan using a Job Separator
71