Press the [Menu] button.
Press the power button on the front of the scanner.

Chapter 4 How to Use the Operator Panel

■Checking and resetting counters

1

D[Ready] is displayed on the LCD.

2

D[Main Menu] is displayed on the LCD.

Menu Function

 

 

/Enter

Send to

Check

Clear

/Pause

 

/Back

 

Stop

 

 

Scan

 

Counter

iMFF Reset Eject

cPower Button

h[U] / [V] Button [Function/Enter] Button

d[Menu] Button

e[U] / [V] Button [Function/Enter] Button

f[U] / [V] Button

g[U] / [V] Button [Counter Reset] Button

3 Press the [U] or [V] button and select [23: Show/Clear Counters], then press the [Function/Enter] button to confirm.

D[Show/Clear Counters] is displayed on the LCD.

4 Press the [U] or [V] button and check the counter.

Counters are highlighted when consumable replacement, maintenance part replacement, or cleaning is required. The counter will appear highlighted when:

zThe page count after replacing the consumable reaches 95% of the value configured in "Specifying the Cycle to Replace Consumables [Life Counter Alarm Setting]" (page 185) in the Software Operation Panel. (For brake roller/pick roller/separator roller counters)

zThe scanner determines that the condition of the roller has exceeded the threshold that can be corrected, by monitoring the wear on the roller. (For assist roller counter)

zThe page count after cleaning reaches 100% of the value configured in "Specifying the Cycle to Clean the Scanner [Cleaning Cycle]" (page 184) in the Software Operation Panel. (Cleaning counter)

zThe amount of remaining ink reaches below 33%. This is only displayed when the imprinter is installed. (For [Ink Level: Front] / [Ink Level: Back])

68