Chapter 4 How to Use the Operator Panel
Items Configurable in the Main MenuItem | Description | Setting/Value | Factory Default |
|
|
|
|
|
|
| |
|
|
|
|
1: iMFF Setting | When there is paper of the same size attached to a designated | 1: Manual mode | 1: Manual mode |
| location on the page, you can have the scanner memorize the | 2: Auto mode 1 |
|
| location of the attachment and not detect the same pattern as | 3: Auto mode 2 |
|
| multifeed. | 4: Clear pattern |
|
| Note that you need to specify [Detect by overlap (Ultrasonic)] in |
|
|
| either the scanner driver’s setup dialog box or the multifeed |
|
|
| detection setting in "Specifying a multifeed detection method |
|
|
| [Multifeed]" (page 207) beforehand. |
|
|
| By selecting [4: Clear pattern], you can clear the overlapping |
|
|
| patterns (length, location) that were previously memorized in Auto |
|
|
| mode. It can also be configured from the Software Operation |
|
|
| Panel. |
|
|
|
|
|
|
2: No. of Paper | Used to change the number of paper feeding retries (when the | 1 to 12 (times) | 3 |
Feed Retries | document is not picked properly). |
|
|
| It can also be configured from the Software Operation Panel. |
|
|
|
|
|
|
3: Pick Speed | When you experience frequent multifeeds and paper jams, the | 1: Normal | 1: Normal |
| symptom may be improved by slowing down the speed in which | 2: Slow |
|
| documents are picked (fed). |
|
|
| It can also be configured from the Software Operation Panel. |
|
|
|
|
|
|
4: Soft Pick | When you experience pick errors from the separator roller slipping | 1: Disable | 2: Enable |
Setting | on the paper, or paper jams from scanning thin papers of small | 2: Enable |
|
| widths, the symptom may be improved by bringing down the pick |
|
|
| roller unit and keeping the unit at the lower position (disabling the |
|
|
| Soft Pick Setting). |
|
|
| It can also be configured from the Software Operation Panel. |
|
|
|
|
|
|
74