Chapter 1 Scanner Overview
1.11 Basic Flow of Scanning Operation
This section explains about the basic flow of scanning operations.
In order to use the scanner to scan documents, you need a scanner driver and an application that supports the driver. There are two scanner drivers bundled with this scanner; a
zFor details about the scanner drivers, refer to the following:
-"Chapter 3 Configuring the Scan Settings" (page 48)
-FUJITSU TWAIN 32 Scanner Driver Help
-ISIS Scanner Driver Help
zFor details about ScandAll PRO, refer to the following:
-How to Use ScandAll PRO
-ScandAll PRO Help
Operation flow differs depending on the interface used to connect the scanner with.
zFor SCSI or USB Connector 1
Perform scanning by using FUJITSU TWAIN 32/ISIS scanner driver
zFor SCSI or USB Connector 2 Perform scanning by using Kofax VRS
The following describes the operation flows for each type of connectors.
1 Turn on the scanner.
For information on how to turn on the power, refer to "1.3 Turning the Power ON/OFF" (page 17).
zWhen connected via SCSI, turn on the scanner and confirm that [Ready] is displayed on the LCD before you turn on the computer.
zWhen switching the connectors, make sure to power off the scanner and the computer first.
2 Load documents on the hopper.
Set the documents with the front side (scanning side) facing up.
For information on how to load documents, refer to "Chapter 2 How to Load Documents" (page 33).
28