Chapter 4 How to Use the Operator Panel
|
| d [Menu] Button |
Menu |
| Function |
|
| /Enter |
Send to | Check | Clear |
/Pause |
| /Back |
| Stop | e[U] / [V] Button |
|
| |
|
| [Function/Enter] Button |
| Scan |
|
Counter
iMFF Reset Eject
f[U] / [V] Button
cPower Button
1
D[Ready] is displayed on the LCD.
2
D[Main Menu] is displayed on the LCD.
3 Press the [U] or [V] button and select [Information], then press the [Function/Enter] button to confirm.
D[Information] is displayed on the LCD.
[Information] can be selected only when there is a message for replacing consumables/cleaning/replacing maintenance parts/regular maintenance.
4 Press the [U] or [V] button to check the contents of the information.
You can check the messages for replacing consumables/cleaning/ replacing maintenance parts/regular maintenance.
When the message prompts replacing consumables/maintenance parts or cleaning, the corresponding counter that requires consumable replacement/maintenance part replacement/cleaning is highlighted.
Counters will appear highlighted when:
zThe page count after replacing the consumable reaches 95% of the value configured in "Specifying the Cycle to Replace Consumables [Life Counter Alarm Setting]" (page 185) in the Software Operation Panel. (For brake roller/pick roller/separator roller counters)
zThe scanner determines that the condition of the roller has exceeded the threshold that can be corrected, by monitoring the wear on the roller. (For assist roller counter)
zThe page count after cleaning reaches 100% of the value configured in "Specifying the Cycle to Clean the Scanner [Cleaning Cycle]" (page 184) in the Software Operation Panel. (Cleaning counter)
zThe amount of remaining ink reaches below 33%. This is only displayed when the imprinter is installed. (For [Ink Level: Front] / [Ink Level: Back]
72